Adjusting The Lcd Screen (Calibration) - Sony Handycam DCR-IP220 Operating Instructions Manual

Troubleshooting

Adjusting the LCD screen (CALIBRATION)

The buttons on the touch panel may not work correctly. If this happens, follow the
procedure below.
(1) Set the POWER switch to (CHG) OFF.
(2) Eject the tape from your camcorder, then disconnect any connecting cable from
(3) Close the LCD panel with the LCD screen facing out.
(4) Set the POWER switch to VCR while pressing DISPLAY/TOUCH PANEL,
(5) Follow the procedure below with your finger or the supplied stylus.
Note
You can only carry out this operation with the LCD screen in the step 3 position.
For details on adjusting the LCD screen (CALIBRATION), refer to the operating
instructions supplied with your camcorder.
108
your camcorder.
then keep pressing DISPLAY/TOUCH PANEL for about five seconds.
1 Touch at the upper left corner.
2 Touch at the lower right corner.
3 Touch in the middle of the LCD screen.
CALIBRATE
If you do not press the right spot,
left corner.
DISPLAY/TOUCH PANEL
CALIBRATE
always returns to the position at the upper
CALIBRATE