How To Use The Remote After You've Programmed It; Using Direct Entry - RCA P42WED33 User Manual

Note: Each time you press PLAY, the remote sends about 10 sets of codes. Therefore, you
might have to press the PLAY button up to 20 times.
If the device you want to operate does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat this step until the device turns
back ON.
2. To fi nish, press and hold STOP until the indicator on the remote turns off.

Using Direct Entry

1. Turn on the device to be programmed.
2. Look up the brand and code number(s) for the device on the code list in this section.
3. Press and hold the device button you want to program on the remote.
4. Enter the code from the remote control code list on the following pages. If the indicator
fl ashes, you have either entered an invalid code or the button isn't programmable.
5. Release the device button.
6. Point the remote at the device. Press ON•OFF to see if the device responds to the
command. If it doesn't, try pressing the device button and then ON•OFF again.
• If you get no response, repeat these steps using the next code listed for your brand, until
the device responds to the remote commands.
• If you try all the codes for your device brand and none work, try the automatic code search
method. If automatic code search doesn't fi nd the code, the remote is not compatible with
your device.

How to Use the Remote After You've Programmed It

Because this universal remote can operate several different devices, it uses operational modes
triggered by the device buttons. For example, if you want the remote to operate the TV, you
would press the TV button to put the remote into TV mode before you could operate the TV.
1. Press the appropriate device button (DVD, TV, VCR) to set the remote to operate the
device.
2. Press ON•OFF to turn the device ON or OFF.
3. Use the remote buttons that apply to that device.
Note: If you keep pressing buttons and nothing happens, the remote is probably in the
wrong mode. You must press the device button that matches the device you want to
operate (i.e., if you want to operate the VCR, press VCR on the remote control to put the
remote in VCR mode.)
Chapter 2
Using the Remote Control
23