Security Menu - Panasonic Toughbook CF-18BCAGCMM Reference Manual

Setup Utility

Security Menu

Execute-Disable Bit Capability
• When [Execute-Disable Bit Capability] is set to [Enable], it means that this computer supports
hardware-based Data Execution Prevention (DEP). It should usually be set to [Enable].
DEP is a set of hardware and software technologies that perform additional checks on memory
to help prevent malicious code from running on a system.
Password on boot
• Select whether you will need to input ([Enable]) or not ([Disable]) the Supervisor Password or
the User Password on booting.
SD Startup
• Select whether to use an SD Memory Card instead of entering the password on booting
([Enable]) or not ([Disable]).
• When registered SD memory card, this is set to [Enable].
• Cannot be set when [Password on boot] is set to [Disable].
SD Setting Method
• Select whether to set an SD Memory Card to [Leave Set] or [Set and Eject] when an SD
Memory Card is used instead of entering the password.
• This can be set only if [SD Startup] has been set to [Enable].
• Cannot be set when [Password on boot] is set to [Disable].
NOTE
When the Setup Utility is started up with the User Password:
• [Clear registered SD card], [Set Supervisor Password], [Hard Disk Lock] and
[Enable Embedded Security Chip (TPM)] will not be displayed.
• [Execute-Disable Bit Capability], [Password on boot], [SD Startup], [SD Setting
Method], [Setup Utility Prompt], [Boot First Menu] and [User Password Protection]
will be displayed, but cannot be set.
• The User Password can be changed only when [User Password Protection] has
been set to [No Protection]. The User Password cannot be deleted.
[SD Startup], [SD Setting Method] and [Clear registered SD card] will be displayed
only when an SD Memory Card has been registered. ( page
(An underline indicates the factory default settings)
109
58)
Disable
Enable
Disable
Enable
Disable
Enable
Leave Set
Set and Eject