Fujitsu ScanSnap S300 Operator's Manual page 20

CAUTION
The following illustrates important cautions described in this manual.
Do not install the scanner on unstable surfaces.
Protect the scanner from static electricity.
Do not use aerosol sprays near the scanner.
Do not use the scanner immediately after moving it from a cold
place into a warm room.
Be careful not to get wet or moistured when carrying the scanner
outside.
Be careful not to cut your fingers
xviii
Install the scanner on a flat, lever surface. Make sure none of the scanner parts
protrudes outside the desktop.
Do not install the scanner on unstable surfaces. Install the scanner on a level
surface that is free of vibration to prevent it from falling.
Install the scanner on a strong surface that will support the weight of the scanner
and other devices.
Install the scanner away from strong magnetic fields and other sources of
electronic noise. Also, protect the scanner from static electricity as this might
cause the scanner to malfunction.
Do not use aerosol sprays to clean the scanner. Aerosol sprays cause dirt and
dust to enter the scanner, resulting in scanner failure and malfunction.
Do not use the scanner immediately after moving it from a cold place into a warm
room. This may cause condensation, which might lead to scanning errors. Let the
device dry about one or two hours before you use it.
When carrying the scanner outside while it is rainy or snowy, pay particular
attention so it does not get wet or moistured.
When handling the paper, be careful not to cut your fingers by the paper.