Including Comments In Acls; Applying An Ip Acl To A Terminal Line - Cisco WS-C3750-48PS-S Software Configuration Manual

Chapter 31 Configuring Network Security with ACLs
30 deny tcp any any time-range christmas_2003 (inactive)
40 permit tcp any any time-range workhours (inactive)
This example uses named ACLs to permit and deny the same traffic.
Switch(config)# ip access-list extended deny_access
Switch(config-ext-nacl)# deny tcp any any time-range new_year_day_2003
Switch(config-ext-nacl)# deny tcp any any time-range thanksgiving_2003
Switch(config-ext-nacl)# deny tcp any any time-range christmas_2003
Switch(config-ext-nacl)# exit
Switch(config)# ip access-list extended may_access
Switch(config-ext-nacl)# permit tcp any any time-range workhours
Switch(config-ext-nacl)# end
Switch# show ip access-lists
Extended IP access list deny_access
Extended IP access list may_access

Including Comments in ACLs

You can use the remark keyword to include comments (remarks) about entries in any IP standard or
extended ACL. The remarks make the ACL easier for you to understand and scan. Each remark line is
limited to 100 characters.
The remark can go before or after a permit or deny statement. You should be consistent about where you
put the remark so that it is clear which remark describes which permit or deny statement. For example,
it would be confusing to have some remarks before the associated permit or deny statements and some
remarks after the associated statements.
To include a comment for IP numbered standard or extended ACLs, use the access-list access-list
number remark remark global configuration command. To remove the remark, use the no form of this
command.
In this example, the workstation belonging to Jones is allowed access, and the workstation belonging to
Smith is not allowed access:
Switch(config)# access-list 1 remark Permit only Jones workstation through
Switch(config)# access-list 1 permit 171.69.2.88
Switch(config)# access-list 1 remark Do not allow Smith workstation through
Switch(config)# access-list 1 deny 171.69.3.13
For an entry in a named IP ACL, use the remark access-list configuration command. To remove the
remark, use the no form of this command.
In this example, the Jones subnet is not allowed to use outbound Telnet:
Switch(config)# ip access-list extended telnetting
Switch(config-ext-nacl)# remark Do not allow Jones subnet to telnet out
Switch(config-ext-nacl)# deny tcp host 171.69.2.88 any eq telnet

Applying an IP ACL to a Terminal Line

You can use numbered ACLs to control access to one or more terminal lines. You cannot apply named
ACLs to lines. You must set identical restrictions on all the virtual terminal lines because a user can
attempt to connect to any of them.
78-16180-02
10 deny tcp any any time-range new_year_day_2003 (inactive)
20 deny tcp any any time-range thanksgiving_2003 (inactive)
30 deny tcp any any time-range christmas_2003 (inactive)
10 permit tcp any any time-range workhours (inactive)
Catalyst 3750 Switch Software Configuration Guide
Configuring IP ACLs
31-19