Switch Port Configuration Commands; Show Interface - Fujitsu XG1200 User Manual

XG1200 User's Guide

5.8 Switch Port Configuration Commands

This section explains configuration commands of each port of the switch.

5.8.1 show interface

Function
Displays the port state of the specified switch.
Prompt
xg>, or xg#
Command syntax
show interface [ { port <1-12> | agg-port <1-6> } ]
Parameter
port <1-12>
Specifies the port number of the switch to display.
agg-port <1-6>
Specifies the aggregation group number of the switch to display.
When "port" parameter and "agg-port" parameter are omitted, the state of all ports will be displayed.
Command type
Operation management commands
Output form
xg# show interface
Interface Information
===============================================================================
[port 1]
Generic Information
MAC Address
Link State
Link Status Detail
STP State
Flow Contorol
Address Learning
Multicast Forwarding
Port Security
Storm Control
Default Qos Priority
Ingress Bandwidth
Vlan Information
Port Default Vlan ID
Vlan Member(tagged frame)
Vlan Member(untagged frame)
User Vlan Protocol ID
Filter Information
Ingress Filter(no vlan member): {Disabled | Enabled}
Ingress Filter(tagged frame)
Ingress Filter(untagged frame): {Disabled | Enabled}
-------------------------------------------------------------------------------
[port 2]
===============================================================================
The setting state of each switch port will be displayed.
[port 1]
The number of the switch port to display is displayed.
In the case of an aggregation group, the aggregation group number such as [agg-port 1] is displayed.
Generic Information
MAC Address
The MAC address of the port is displayed.
Link State
−
−
: 000C.123a.4321
: { Link-up | Link-down }
: detail information
: { Discard | Learn | Forward }
: { Rx Only | Rx and Tx }
: { Enabled | Disabled }
: { Forward-all | Forward-unregistered-mac
: { Shutdown | Restrict | Disabled }
: { Enabled | Disabled }
: <0-7>
: <40-10000> (total:<240-60000>)
: <1-4094>
: { None | Vlan-1 Vlan-2
: { None | Vlan-1 Vlan-2
: <0x05DD ~ 0xFFFF>
Link-up
Shows the port is in link down state.
Link-down
Shows the port is in link up state.
All Rights Reserved, Copyright (C) PFU LIMITED 2005
2005/08/22-12:12:15
| Filter-unregistered-mac }
: {Disabled | Enabled}
105/258
}
}