Config 802.1X Capability Ports; To Configure 802.1X Capability On Ports 1-10 - D-Link DES-3010F Command Line Interface Reference Manual

config 802.1x capability ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To configure 802.1x capability on ports 1-10:

DES-3026:4#config 802.1x capability ports 1–10 authenticator
Command: config 802.1x capability ports 1–10 authenticator
Success.
DES-3026:4#
DES-30XX Layer 2 Switch CLI Reference Manual
DES-3026:4#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
802.1X
Authentication Mode
Authentication Protocol : Radius_Eap
Port number : 1
Capability : None
Port Status : Authorized
PAE State : ForceAuth
Backend State : Success
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60
TxPeriod : 30
SuppTimeout : 30
ServerTimeout : 30
MaxReq : 2
ReAuthPeriod : 3600 sec
ReAuthenticate : Disabled
CTRL+C ESC q Quit SPACE n
Used to configure the 802.1x capability of a range of ports on the Switch.
config 802.1x capability ports [<portlist> | all] [authenticator | none]
The config 802.1x command has four capabilities that can be set for each
port. Authenticator, Supplicant, Authenticator and Supplicant, and None.
<portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
authenticator − A user must pass the authentication process to gain access
to the network.
none − The port is not controlled by the 802.1x functions.
Only administrator-level users can issue this command.
: Enabled
: Port_based
sec
sec
sec
sec
times
Next Page Enter
132
Next Entry a All