Cisco WIC-1ENET - 1700 Access Routers 1port10bt Enet Wan Interface(man Configuration Manual page 17

After the configuration you entered appears, you are asked whether you want to use it.
Enter yes to save the startup configuration:
Step 8
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
The configuration is saved. Otherwise, enter no. The information you entered is discarded, and you can
reenter the configuration parameters.
Router Configuration Scenarios
The following examples shows a Cisco 1700 series router configured to use the Cisco WIC-1ENET.
These are sample configurations. For descriptions of the features and commands, see the configuration
guidelines on the Cisco website.
Figure 2
IP/ATM
Example PPPoE Client Configuration
Point-to-Point Protocol (PPP) over Ethernet (PPPoE) offers a familiar dial interface to subscribers over
customer premises equipment (CPE), as shown in
separate PPP sessions. It allows hosts connected to CPE to establish PPP sessions. When the router is
running PPPoE, hosts connected to the router are not required to run individual PPP sessions.
78-11422-03
interface Ethernet0
ip address x.x.x.x x.x.x.x
!
router igrp 1
redistribute connected
network x.x.x.x
network x.x.x.x
!
end
Example Configuration
Modem
DSL/Cable
Cisco
1720
12.0.0.x
WIC-1ENET
FE
Figure 2. It allows PCs connected to CPE to establish
Connecting a Cisco WIC-1ENET Card to the LAN
Router Configuration Scenarios
17