Cisco ME-C3750-24TE-M Hardware Installation Manual page 156

Entering the Initial Configuration Information
Enter a virtual terminal (Telnet) password, and press Return.
Step 5
The password can be from 1 to 25 alphanumeric characters, is case sensitive,
allows spaces, but ignores leading spaces.
Enter virtual terminal password: terminal-password
(Optional) Configure Simple Network Management Protocol (SNMP) by
Step 6
responding to the prompts. You can also configure SNMP later through the CLI
or CMS interface. To configure SNMP later type no.
Configure SNMP Network Management? [no]: no
Enter the interface name (physical interface or VLAN name) of the interface that
Step 7
connects to the management network, and press Return. For this release, always
use vlan1 as that interface.
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Configure the interface by entering the switch IP address and subnet mask and
Step 8
pressing Return. The IP address and subnet masks shown below are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.0.0.0
Enter Y to configure the switch as the cluster command switch. Enter N to
Step 9
configure it as a member switch or as a standalone switch.
If you enter N, the switch appears as a candidate switch in the CMS. You can
configure the switch as a command switch later through the CLI or CMS
interface. To configure it later type no.
Would you like to enable as a cluster command switch? [yes/no]: no
You have now completed the initial configuration of the switch and the switch
displays its initial configuration. This is an example of output that appears:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password enable_password
line vty 0 15
password terminal-password
no snmp-server
!
no ip routing
Catalyst 3750 Switch Hardware Installation Guide
D-12
Appendix D Quick Setup By Using the CLI-Based Setup Program
78-15136-02