Performing Installation Cycle - Electrolux EWFLS70J Installation Instructions Manual

Performing Installation Cycle

If your washer has this console:
1. Empty washer's drum and close door.
2. After you plug in the washer the fi rst time: wake up the washer by pressing any button, rotate cycle
knob to hand wash cycle, press the start button and then the cancel button.
3. Wake up the washer again by pressing any button, then immediately and simultaneously press and
hold both the eco friendly and my favorite buttons for 5 seconds, or until the LCD display changes.
4. The LCD window will display
start button. The Installation Cycle will automatically test for if water has been turned on. At cycle
completion, the LCD window may display
and ready for use. If it prompts an action such as
CALL SERVICE 877 435 3287
fore you attempt to use the washer.
5. Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up.
6. Please read the Use & Care Guide and enjoy your new premium washer!
If your washer has this console:
1. After you plug in the washer the fi rst time: wake up the washer by pressing any button and then follow
the prompts on the LCD User Interface, including language selection.
2. The Installation Cycle will automatically test for, and if water has been turned on. At cycle completion,
the LCD window may display
for use. If it prompts an action such as
CALL SERVICE 877 435 3287
fore you attempt to use the washer.
3. Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up.
4. Please read the Use & Care Guide and enjoy your new premium washer!
Installation Instructions
INSTAL CYCLE
and show estimated time of cycle completion. Press the
INSTAL PASS!
NO WATER
, review the installation steps and make the necessary corrections be-
NOTE
Washer will stay awake for 3 minutes after the
Installation Cycle. If you wish to immediately run the
washer through a washing cycle, press the cancel
button to put the unit to sleep and then rewake it
immediately to continue the normal operating mode.
INSTAL PASS!
, meaning your new washer is properly installed and ready
NO WATER
, review the installation steps and make the necessary corrections be-
NOTE
Washer will stay awake for 3 minutes after the
Installation Cycle. If you wish to immediately run the
washer through a washing cycle, press the cancel
button to put the unit to sleep and then rewake it
immediately to continue the normal operating mode.
, meaning your new washer is properly installed
CHECK HOSES
,
CHECK HOSES
, or
or
11