Table of Contents
Advertisement
Chapter 2
Using the Setup Command Facility
Step 2
When the messages stop displaying on your screen, press Return to get the
Note
%AT-6-ONLYROUTER: Ethernet0/0: AppleTalk port enabled; no neighbors found
Step 3
The
completed a basic router configuration. However, this is not a complete configuration. At this point you
have two choices:
•
2600> enable
Password: password
2600# setup
•
Where to Go Next
At this point you can proceed to the following:
•
•
OL-1957-03
If you see the next message, it means that no other AppleTalk routers were found on the
network attached to the port.
prompt indicates that you are now at the command-line interface (CLI) and you have just
2600>
Run the setup command facility again and create another configuration. Enter the following:
Modify the existing configuration or configure additional features with the CLI as described in
Chapter 3, "Configuring with the Command-Line Interface."
"Chapter 3, "Configuring with the Command-Line Interface,"
configure additional features.
The Cisco IOS software configuration guide and command reference publications for more
advanced configuration topics. These publications are available on Cisco.com, the Documentation
CD-ROM that came with your router, or you can order printed copies. For more information, refer
to
"Obtaining Documentation."
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Where to Go Next
prompt.
2600>
to learn how to use the CLI to
2-25
Hide quick links:
Advertisement
Table of Contents
