Power Connections; Connecting Routers To Ac Power - Cisco 2612 Hardware Installation Manual

Chapter 3 Installing the Router
Figure 3-21 Ground Connection Using Ring Terminal, Cisco 2691
Ring terminal
attachment
After the router has been installed and properly grounded, you can connect the power wiring; the WAN,
LAN, and voice cables; and the cables for administrative access, as required for your installation. For
cable connection procedures, see the
LAN, and Voice Cables" section on page
section on page

Power Connections

Read the installation instructions before connecting the system to the power source. Statement 1004
Warning
Do not work on the system, or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
Note The installation must comply with all required electrical codes applicable at the installation site.
This section explains how to connect AC or DC power to Cisco 2600 series routers. It covers the
following topics:
•
•
•

Connecting Routers to AC Power

If your router uses AC power, connect it to a 15 A, 120 VAC (10 A, 240 VAC) circuit with overcurrent
protection.
The input voltage tolerance limits for AC power are 85 and 264 VAC.
Note
OL-2171-06
AS YN C
31
27
30
26
29 AS YN C
28 25 24- 31
24
23
19
22
15
21 18 AS YN C
14 11
17 16- 23
10 20
13 AS YN C 16
12 9 8-1 5
8
7
3
6
5 2 AS YN C
1 0-7
4
0
3-20.
Connecting Routers to AC Power, page 3-15
Connecting Routers to a DC-Input Power Supply, page 3-16
Connecting Routers to the Cisco Redundant Power System, page 3-18
SEE MAN
UAL BEF
DSU
ORE INS
EN TAL LAT ION
56K
ACT
100 Mbp SEE MAN
s UAL BEF
ORE INS DSU
LINK TAL LAT ION 56K
ACT
CF1
100 Mbp
s
FAST ETH
ERN ET
0/1 LINK SEE MAN
FAST ETH
ERN ET
0/0
CI SC O 26
91
CON SOL
"Power Connections" section on page
3-18, and the "Connecting to a Console Terminal or Modem"
Cisco 2600 Series Routers Hardware Installation Guide

Power Connections

UAL BEF
ORE INS
TAL LAT ION
E
AUX
3-15, the "Connecting WAN,
3-15