Verifying the Installation
Figure 2-8
Connecting Power
10 0- 24
0V ~
1. 5 M AX
/1 .5 A M
AX
50 -6 0
Hz
Step 2
Step 3
Step 4
Verifying the Installation
Cisco 1760 Modular Access Router Hardware Installation Guide
2-12
Connect the other end of the separate power cord to a power outlet.
Turn the power switch on ( | ).
Confirm that the router has power by checking that the PWR LED is on.
You can verify that you have correctly installed the router by checking the
following LEDs:
PWR—On when power is being supplied to the router.
•
OK—On when the router software is loaded and functional. Blinking means
•
that the router is performing a power-on self-test (POST).
ETH ACT—Blinking when there is network traffic on the local Ethernet
•
LAN.
Chapter 2
Installation
78-13342-03