D-Link DWL-G650 Quick Install Manual page 8

Appendix
G. SSID: The Service Set
Identifier is the name as-
signed to the wireless
network. The factory SSID
setting is set to default. Make
changes here to match the
SSID on existing Wireless
Router or Access Point.
G
H
I
J
K
L
J. TxRate: You can
adjust the transmis-
sion rate to get the
best signal possible
depending on your
usage and your
environment.
The preamble setting
Router or Access Point in order to communicate on the network.
H. Wireless Mode:
The factory setting is
set to Infrastructure.
Ad-Hoc mode is used
for peer-to-peer
networking.
K. Preamble: By default,
D-Link Air Products are set to
Auto Preamble. The Preamble
defines the length of the CRC
block (Cyclic Redundancy
Check is a common technique
for detecting data transmis-
sion errors) for communica-
tion between the Access Point
and wireless network adapt-
ers. High network traffic areas
should use the shorter
preamble type.
of the DWL-G650 must match the preamble setting of the Wireless
I. Channel: By default, the
channel is set to 6. Channel
selection is automatically
determined by the DWL-G650
depending on the channel
setting of the access point
selected for association. To
change the channel settings,
the Wireless Mode must be
set to Ad-hoc.
L. Power Mode: By default,
Power Mode is set to
Continuous Access Mode.
Continuous Access Mode
— this default setting
consumes the most power.
Maximum Power Save —
this setting consumes the
least power. Power Save
— this setting consumes a
moderate amount of power.