Cisco Catalyst 3560X-24P Command Reference Manual page 899

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
Examples This example shows how to cause an interface to cease operating as a Layer 2 port and become a
Cisco-routed port:
Switch(config-if)# no switchport
This example shows how to cause the port interface to cease operating as a Cisco-routed port and convert
to a Layer 2 switched interface:
Switch(config-if)# switchport
The switchport command without keywords is not used on platforms that do not support Cisco-routed
Note
ports. All physical ports on such platforms are assumed to be Layer 2-switched interfaces.
You can verify the switchport status of an interface by entering the show running-config privileged
EXEC command.
Related Commands Command
show interfaces
show running-config
OL-21522-02
Description
switchport Displays the administrative and operational status of a switching
(nonrouting) port, including port blocking and port protection settings.
Displays the operating configuration. For syntax information, use this
link to the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_com
mand_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to
navigate to the command.
Catalyst 3750-X and 3560-X Switch Command Reference
switchport
2-867