Specific Absorption Rate (Ieee) - Motorola ADMIRAL User Manual

Implantable Medical Devices
If you have an implantable medical device, such as a pacemaker or defibrillator, consult your
physician before using this mobile device.
Persons with implantable medical devices should observe the following precautions:
● ALWAYS keep the mobile device more than 20 centimeters (8 inches) from the
implantable medical device when the mobile device is turned ON.
● DO NOT carry the mobile device in the breast pocket.
● Use the ear opposite the implantable medical device to minimize the potential for
interference.
● Turn OFF the mobile device immediately if you have any reason to suspect that
interference is taking place.
Read and follow the directions from the manufacturer of your implantable medical device. If you
have any questions about using your mobile device with your implantable medical device,
consult your healthcare provider.

Specific Absorption Rate (IEEE)

YOUR MOBILE DEVICE MEETS FCC LIMITS FOR EXPOSURE TO RADIO WAVES.
Your mobile device is a radio transmitter and receiver. It is designed not to exceed the limits for
exposure to radio waves (radio frequency electromagnetic fields) adopted by the Federal
Communications Commission (FCC). These limits include a substantial safety margin designed
to assure the safety of all persons, regardless of age and health.
The radio wave exposure guidelines use a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit for mobile devices is 1.6 W/kg.
Tests for SAR are conducted using standard operating positions with the device transmitting at
its highest certified power level in all tested frequency bands. The highest SAR values under the
FCC guidelines for your device model are listed below:
ESMR CDMA mode (Part 90):
Head: 0.93 W/kg; Body-worn: 0.67 W/kg
Cellular CDMA mode (Part 22):
Head: 1.02 W/kg; Body-worn: 0.73 W/kg
PCS mode (Part 24):
Head: 1.06 W/kg; Body-worn: 0.44 W/kg
During use, the actual SAR values for your device are usually well below the values stated. This
is because, for purposes of system efficiency and to minimize interference on the network, the
Important Safety Information 117