Smeg SWM812ES User Manual
Smeg SWM812ES User Manual

Smeg SWM812ES User Manual

Full electronic washing machine

Advertisement

FULL ELECTRONIC
WASHING MACHINE
USER MANUAL

Advertisement

Table of Contents
loading

Summary of Contents for Smeg SWM812ES

  • Page 1 FULL ELECTRONIC WASHING MACHINE USER MANUAL...
  • Page 2: Table Of Contents

    SECTION 6:MAINTENANCE AND CLEANING Water inlet filters Pump filter Detergent drawer Siphon plug The cabinet The drum Remove of your machine from lime SECTION 7: PRACTICAL INFORMATION SECTION 8:AVOIDING MINOR FAULTS SECTION 9:AUTOMATIC FAILURE DETECTION SYSTEM SECTION 10:INTERNATIONAL WASHING SIGNS...
  • Page 3: Section 1:Before Using

    Since the machine can reach high temperatures while running, do not touch the drain hose and water during draining. In case of any failure, first unplug the device and close the water tap. Do not attempt to repair.Please apply to the nearest authorized service station.
  • Page 4: Section 2:Installation

    If you will not use your machine for a long time, unplug your machine, close the water supply and leave the door open in order to keep the inside of the machine dry and for prevention from unpleasant odour. As a result of the quality control procedures, a certain amount of water may remain in your machine.
  • Page 5: Adjustment Of Feet

    10 ampere. The fuse flow value of the electricity line attached to this should also be 10 ampere. If you have no such sockets and fuses in your house, let it be made by a qualified electrician.
  • Page 6: Water Drain Connection

    Water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from the ground. The end of the water drain hose may directly be fitted to the dirty water outlet hole or a special apparatus mounted on the outlet bracket of the wash-stand.
  • Page 7: Section 3:Technical Specifications

    SECTION 3:TECHNICAL SPECIFICATIONS Maximum dry laundry capacity (kg) Recommended loading (kg) Height (cm) Width (cm) 59,6 Depth (cm)
  • Page 8: Section 4:Control Panel

    SECTION 4:CONTROL PANEL 1- Detergent drawer 6-Spin speed selector 2- Program knob 7- Function buttons 3-Temperature adjustment knob 4- Washing operation light 5- Start/pause and cancel button...
  • Page 9: Start/Pause Button

    When any one of these lamps is on it means that certain programme is in use. The lamp is off when any function button or the start/hold button is pressed, or the selected function has finished its operation.
  • Page 10: Function Buttons

    The lamp above the function button will flash. Start the programme by pressing the start/hold button. Extra rinse You can have one more rinsing done in addition to the rinses which your machine has made in all washing programs by using this function.
  • Page 11 WARNING! If you have forgotten to use an additional function and the machine has started the wash operation press the button of the additional function you wish to select; if the indicator lamp above it keeps lighting the additional function you selected will become active.
  • Page 12: Spin Speed Selector

    SPIN SPEED SELECTOR By the spin speed selector knob, you can make the adjustment of speed for the process of spinning your clothes.The speed adjustment interval is between O (No spin) and the maximum spinning speed of your machine. NOTE: Do the spinning process of your sensitive and delicate clothes in the most appropriate mode.
  • Page 13: Program Knob

    You must be careful that the adjustment sign of the program knob is exactly on the program you want to select. When you bring the programme knob to off position, your machine will carry out the drain operation in order to finish (cancel) programme cycle.After drain is...
  • Page 14: Section 5:Washing Your Laundry

    Since your new coloured clothes may shed dye on the first wash, wash them separately. Be careful that no metal pieces are found on or in the pockets of your clothes, remove if there is any. Zip and button your clothes.
  • Page 15 Wash your small clothes like socks and handkerchiefs in a washing bag. Wash up tol 90 C Wash up to 60 C Wash up to 30 C Not washable in washing machine Placement of the clothes into the machine Open the door of your machine.
  • Page 16: Running The Machine

    When you wish to put the selected programme on pause press the start/pause button once. The lamp above it will start to flash. In order to restart the programme from the point it was put on pause at you will have to press the start/pause button once again.
  • Page 17 If the programme you selected is a wash programme the wash operation lamp will light If the programme you selected is a rinse/spin or drain programme the lamps indicating the related selection will light up. In order to select an additional function: Press once the additional function button you wish to select.
  • Page 18 You can open the door and take out the laundry by pulling the door handle towards yourself. After you have taken out the laundry leave the door open so that the machine interior can dry.
  • Page 19 If there is water in the machine do not open the door or the water will pour out. If you wish to take out your laundry you can do so by draining the water inside the machine following the instructions explained in the section “cleaning the pump filter”...
  • Page 20 (2 minute for door opening is not included in the washing period.) When you need an additional rinsing to be done to your clothes after the washing process, you can use this program for all kinds of clothes. RINSE You can use this program, when you need an additional spinning to be done to your clothes after the washing process.
  • Page 21: Section 6:Maintenance And Cleaning

    Close the water tap. WATER INLET FILTERS On the tap part of your machine’s water inlet hose and at the ends of water inlet valves, there are filters to prevent entrance of the dirt and foreign materials in the water to the machine. If the machine is unable to receive sufficient water although your water tap is opened, these filters should be cleaned.
  • Page 22: Detergent Drawer

    WARNING! Danger of being scalded! Since the water inside the pump maybe hot, wait for it to cool. DETERGENT DRAWER Detergents may cause residue buildup in the detergent drawer and in its slot over time. Take out the detergent drawer periodically to clean up the accumulated residue.
  • Page 23: Siphon Plug

    Close the water tap and pull out the water inlet hose or hoses from the tap. Place the ends of the water drain and water inlet hoses in a cup on the ground. Adjust the program knob to “Draining” program.
  • Page 24: Section 7:Practical Information

    Chocolate and cocoa: By leaving your clothes in cold water and rubbing with soap or detergent, wash it in the highest temperature that the type of your cloth can endure. If there is still a stain of oil left, wipe with oxygenated water (in proportion of 3%).
  • Page 25: Section 8:Avoiding Minor Faults

    Then it should be rubbed with detergent and washed. Burnt stain: If your cloth is suitable for use of lye, you can add lye into your washing water. For woolen fabric, a cloth damped in oxygenated water should be covered on the stain and it should be ironed with a dry cloth on it.
  • Page 26 The feet of your machine are not Adjust the feet. (**) Your machine is adjusted. vibrating. Transportation screws Remove transportation are not removed. screws. (**) (*)See the section concerning the maintenance and cleaning of your machine. (**)See the section concerning installations your machine.
  • Page 27 . Press the start/pause button.In order to stop the foam,dilute one table-spoon of softener in half liter of water and pour it in the detergent Too much detergent drawer.Press the has been used. start/pause button after Excessive foam in the 5-10 minutes.Arrange...
  • Page 28 In the next washing These stains may be operation, use the There are gray stains caused by oil,cream or maximum detergent on the clothes. ointment . amount declared by the detergent producer. (**) See the section concerning instalations your machine.
  • Page 29: Section 9:Automatic Failure Detection System

    SECTION 9: AUTOMATIC FAILURE DETECTION SYSTEM Your machine is equipped with systems which will both take the necessary precautions and warn you in case of any failure by controlling it self constantly during the washing processes. FAILURE PROBABLE...
  • Page 30 The 2 and 3 excessive process,shut number light amount of down your blinks. water in your machine and machine. unplug. Close the tap and apply to the nearest authorized service. (*) See the section regarding the maintenance and cleaning of your machine.
  • Page 31 FAILURE PROBABLE THE PROCESS FAILURE CODE INDICATOR FAILURE TO BE DONE Shut down your machine and unplug. Turn off The 3 and 4 The motor the tap and number light has failed. apply to the blink. nearest authorized service.
  • Page 32: Section 10:International Washing Signs

    Do not bleach. Handy to bleach. All of these are dry cleaning symbols. The letters are to instruct the cleaner what type of solvent to be used. Garments bearing these symbols should not be washed in your machine unless the label says otherwise.

Table of Contents