Zoetis. Zoetis reserves the right to modify its products and services at any time. This user’s manual is subject to change without notice. Although prepared to ensure accuracy, Zoetis assumes no liability for errors, or for any damages resulting from the application or use of this information.
Intended Use The Vetscan Hub is a touch screen user interface for Vetscan diagnostic systems, allowing customers to manage their diagnostic worklist and connect to compatible practice information management software (PIMS). The Vetscan Hub is intended for veterinary use only.
• Over-the-Air (OTA) analyser software updates The Vetscan Hub is comprised of a single touch screen user interface, power adapter, country specific power cord, Ethernet cable, and quick start guide. User interface Power cord...
The Vetscan Hub can be powered off by pressing the power button on the top of the Vetscan Hub and holding it for 5 seconds. The Vetscan Hub is designed to be left on at all times, except when it will not be used for long periods (i.e., troubleshooting or repair).
Step 2: Plug the power cord into the power adapter. Insert the connector of the power adapter cord on the back of the Vetscan Hub and gently screw in until tight. Plug the other end of the power cord into a grounded electric outlet.
— dampen the cloth instead. Cleaning the Stand Clean the Vetscan Hub stand with a soft cloth, dampened with a mild, non-abrasive detergent or cleaning solution, such as a 10% bleach solution, or a 30% isopropyl alcohol solution. Pre-soaked towelettes (isopropyl alcohol) may be used as an alternate.
The Vetscan Hub is not intended to be serviced by operators. Any Vetscan Hub that requires servicing needs to be returned to Zoetis for repair or replacement. Do not open the Vetscan Hub as opening may create a hazardous situation for you and will void the warranty. This device must be serviced by authorised technicians when: •...
Date of manufacturing at production site in Taiwan Serial number Caution Indoor use Importer Indicates the identity and address of the importer WEEE Indicates that separate collection for waste of electric and electronic equipment (WEEE) is required CE Mark European Conformity 11 | Vetscan Hub User’s Manual...
Appendix D: Safety and Regulatory Compliance Safety Warning Labels Warning labels posted on the Vetscan Hub and in this manual warn you about potential sources of injury or harm. Refer to Appendix C: Symbols to review the meaning of each safety warning label.
This device is in compliance with the EU directives 2011/65/EU (RoHS2) including amendments, 2014/30/EU (EMC), and 2014/35/EU (Low Voltage). The current version of the Declaration of Conformity can be retrieved within the Vetscan Hub application under Settings. 13 | Vetscan Hub User’s Manual...
Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. 14 | Vetscan Hub User’s Manual...
Cet appareil est conforme aux normes RSS exempts de licence d’Industrie Canada. Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas causer d’interférences et (2) cet appareil doit accepter toute interférence, y compris les interférences pouvant provoquer un fonctionnement indésirable de l’appareil. 15 | Vetscan Hub User’s Manual...