Switching Off; Removing The Dishes; To Save On Energy And Protect The Environment; To Cut Down On Detergent Consumption - Smeg DI112 Instruction Manual

TO SAVE ON ENERGY! ... AND PROTECT THE ENVIRONMENT
•
Always use the dishwasher with a full load.
•
Do not wash the dishes in running water.
•
Use the washing program that is most appropriate for each type of
load.
•
Do not carry out any preliminary rinsing.
•
If available, connect the dishwasher to a hot water supply up to 60°C.
TO CUT DOWN ON DETERGENT CONSUMPTION! ... AND PROTECT
THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the
environment. To avoid using excessive amounts of detergent and to save
on electricity, observe the following:
•
separate the more delicate items from dishes that are more resistant
to aggressive detergents and high temperatures;
•
do not pour the detergent directly on the dishes.
If the door has to be opened while washing is in progress, the program
will be interrupted. The relative light will keep flashing and a beeper will
signal that the cycle has not been completed. You must wait about 1
minute before closing the door to restart the program. When the door is
closed the program will continue from where it was interrupted. This
operation should only be carried out if strictly necessary, because it
might cause problems in execution of the program.

SWITCHING OFF

At the end of the program the beeper
sounds briefly and the lights of programs no.
4 and 5 (marked "end") flash.
To switch off the dishwasher, open the door and press the ON/OFF
button (1).

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before
removing the dishes, to allow them to cool. To ensure that any drops of
water left in the top basket cannot drip onto the dishes still in the bottom
basket, you are advised always to empty the bottom basket first.
18
User instructions