Smeg CWC600 Manual page 8

SETTINGS
During start-up, the functions/parameters listed below must be set or adjusted:
On first installation, a series of operations can be performed to allow the dishwasher to be customised to the user's
needs. A short testing cycle can also be performed to verify operation of all the components. To perform these
operations, access "programming mode" as explained below
6.1 Dishwasher parameter modification procedure:
(ONLY ACCESSIBLE AFTER FILLING IS COMPLETE or WITH THE DOOR OPEN)
Indicator lights as follows:
Access "programming mode" by pressing the
seconds (UnLo 1:58 will appear on the display) with the appliance on (after the
filling and heating phase); at the "beep", release the button and press it
again quickly within 0.5 seconds. Keep pressing the button again to scroll
through all the modifiable parameters in the following order:
Rinse aid delivery amount
Detergent delivery amount
Rinsing temperature
Washing temperature
Start-on/start-off.
Set at "on" to start the cycle when the door is closed.
Set at "off" for cycle start after confirmation with the start button
Regeneration frequency, depending on water hardness (if softener is installed)
tStP on/off
"on" = minimum rinsing temperature as set, regardless of intake water
temperature; the cycle duration may be a few seconds longer than the nominal
length.
"off" = the minimum rinsing temperature might be a few degrees lower than
the setting if hot intake water is not used.
7
6 SETTINGS
off; green; orange; flashing.
on/off button for a few