First Installation; First Installation Settings; Channel Search; Scan Failure - Philips DTR2520 User Manual

First installation

For fast and successful start-up, check that your receiver is connected to the wall socket,
TV set and other equipment according to the diagrams in chapter Connecting your
receiver. Switch on the receiver and TV set.The welcome screen appears, then the First
Installation screen.

First Installation settings

- Select the display format corresponding to your TV set.
- Press OK to start scanning for channels.

Channel Search

During the scanning, the following information is
reported:
• TV and Radio channels detected
• Scan progress.
When scanning has been successfully completed, the
receiver tunes to the first channel in the list.

Scan failure

If scanning has failed, the First Installation screen is
displayed again.
Before starting a new scan, check the following points:
- Coverage of your area:
see http://www.freeview.co.uk
- Aerial cable condition and connection to your digital
receiver
For comprehensive connection diagrams:
see http://www.p4c.philips.com
- Aerial position in case the bar graph revealed a poor
quality signal during the previous scan.
Call a specialist if needed.
Then, press OK to perform a new scan.
If scanning keeps failing, refer to chapter Troubleshooting.
Contact your customer service adviser if the problem
remains.
To add channels newly become available, refer to
Channels installation.
To reinstall all channels, refer to Factory Reset.
EN
15