Advertisement
5 | English
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your machine does not operate properly.
If these do not identify and correct the problem, contact your service agent.
Warning: Switch off before investigating fault.
Warning: In the event of an accident or tool breakage, stop the machine immediately and remove the battery.
Problem
Machine fails to operate
Garden tool functions
intermittently
Excessive vibrations/
noise
Run time per battery
charge too low
Machine blow
Reduced airflow
Tube cannot be mounted
on the machine
Flashing red battery
charge indicator
No charging procedure
possible
Battery charge indicators
do not light up
Maintenance and Service
Maintenance, Cleaning and Storage
X Have your product serviced only by a qualified
specialist using only original replacement parts.
This will ensure that the safety of the product is
maintained.
X Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorised service providers.
Possible Cause
Battery discharged
Battery not fully connected
Battery too hot/cold
Machine defective
On/Off switch defective
Controller for airflow speed damaged
Machine defective
Battery has not been used for long period or
only for short terms
Defective battery
Tube obstructed
Air inlet obstructed
Battery too cold
Incorrect assembly
Battery not (properly) inserted
Battery contacts contaminated
Battery defective
Mains plug of battery charger not plugged
in (properly)
Socket outlet, mains cable or battery
charger defective
Corrective Measure
Recharge battery
Insert the battery correctly (see figure C)
Allow to cool/warm. Always start the
product at a low speed
Contact dealer.
Contact dealer.
Contact dealer.
Contact dealer.
Charge battery completely
Replace battery
Clear tube
Clear air inlet
Allow to warm
Mount the tube correctly (see figure B)
Properly insert battery in charger
Clean the battery contacts (e. g. by inserting
and removing the battery several times) or
replace the battery
Replace the battery
Insert mains plug (fully) into the socket
outlet
Check the mains voltage; have the battery
charger checked by an authorised after-
sales service agent for Honda power tools
After-Sales Service and Application Service
In the unlikely event that you encounter a problem with
your product, please contact your Honda authorised
service dealer.
Advertisement
