Table of Contents
Advertisement
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 Introduction
The appliance does not start or it stops during
operation. First try to find a solution to the
problem (refer to the tables).
Problem
1 flash
The appliance does not fill
with water properly.
2 flashes
The appliance does not
drain the water.
4 flashes
The appliance door is open
or not closed correctly.
Once the problem has been eliminated, press
the button Start/Pause to restart the
programme. If after all checks, the problem
persists, contact your Authorised Service
Centre.
Problem
The programme does not
start.
Possible cause/Solution
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For this informa‐
tion, contact your local water authority.
•
Make sure that the inlet hose has no kinks, damages or bends.
•
Make sure that the water tap is not clogged.
•
Make sure that the connection of the water inlet hose is correct.
•
Make sure that the filter of the inlet hose and the filter of the valve are not clog‐
ged. Refer to "Care and cleaning".
•
This problem may be also caused by the clogged drain circuit. Please contact
the Authorised Service Centre.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the hoses have no kinks, damages or bends.
•
Set the drain programme if you set a programme without drain phase.
•
Set the drain programme if you set an option which ends with water in the tub.
•
Make sure that the laundry is evenly distributed in the drum.
•
Make sure that the door is properly closed.
Possible cause/Solution
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that the appliance door is closed.
•
Make sure that there is no damaged fuse in the fuse box.
•
Make sure that the Start/Pause has been touched.
•
Check the position of the knob on the selected programme.
•
If the delay start is set (if available), cancel the setting or wait for the end of
countdown.
WARNING!
Deactivate the appliance before carrying
out any check.
With some problems indicator of the END of
programme blinks:
13.2 Possible failures
In case of different problem with the washing
machine check the table below for possible
solutions.
ENGLISH
23
Advertisement
Table of Contents
