Programming A Pause; To Clear All Of The Program Contents; To Erase A Program (Pd-M435 Only); To Check The Program Contents (Pd-M435 Only) - Pioneer PD-M435 Operating Instructions Manual

TO PLAY ONLY DESIRED TRACKS/DISCS
Programming a pause i
| To check the program contents (PD-M435 only). |
Inserting a pause in your program can be very useful when carrying
out recording. Press PAUSE instead of entering a track number.
"PA" appears on the display panel.
@ For example, when recording on both sides of a cassette tape,
if you program a pause after the last track to be recorded on
the first side, program playback will pause at that point to
allow you to switch tape sides. To resume program playback
after the player enters pause mode, press PAUSE.
Notes:
@ A pause cannot be programmed at the beginning of a program
{P-01}, and two pauses cannot be programmed one after the
other.
@ A pause inserted in a program is counted as one step.
@ /f a pause is programmed as the last step of a program, the
player will not enter the pause mode.
| To clear all of the program contents |
Be =
) ee
/)
During stop mode, press STOP/CLEAR.
When the magazine is ejected, the program contents will be
cleared.
| To erase a program (PD-M435 only) |
ee
Press CLEAR on the remote control unit.
The last program step is erased and the contents of the previous
program step are displayed.
NOTE:
Contents of a program can be erased during playback as well.
However, tracks preceding the currently playing track cannot be
erased in this way.
CHECK =] 1B mer of
/?
cS
ee
@ 9-p4y ""P- fal
c17"e @ S@
(3
Sf
Press CHECK on the remote control unit. The program contents
will be displayed in the programmed order,
e After confirming the last program step, the display will show
"0-00".
To modify the program contents (PD-M435 only)
1
(ca
»
2 = 5 bi PGM
I CoO" CoO» CI
Uf 47 /)
1. Press CHECK so that the program step to be corrected appears
on the display.
2. To correct the disc No., enter the new disc No. with the DISC
NUMBER buttons. To correct the track No., press Kt or bb}
so that the desired track No. appears on the display. After
correcting the disc No. and /or track No., press PROGRAM.
For example, the programmed track No. 4 on the disc No. 3.is
changed to track No. 7 on the disc No. 5, using DISC NUMBER
5, mei and PROGRAM.
# Repeat steps 1 and 2 to change other tracks as desired.
13
<PRB1124>
En