Table of Contents
Advertisement
• before you touch the Start/Pause
button - the appliance cannot start
• after you touch the Start/Pause
button - programs and option
selection is unavailable.
Child lock option activation:
1. Turn the dryer on.
2. Select 1 of the available programs.
3. Touch and hold down + Anti Crease
button by around 3 seconds.
The symbol
appears on the display.
4. To deactivate the child lock, touch
the above button again until the
symbol disappears.
10.9 Starting a program
To start the program:
Touch the Start/Pause button.
The appliance starts and the LED above
the button stops flashing and stays on.
10.10 The ProSense load
detection
The ProSense The
ProSense technology
detects the laundry load size
defining the program
duration.
After setting a drying program, the
icon lights up on the display
if the program supports it.
Touching the Start/Pause button, the
ProSense starts the laundry load
detection:
1. The appliance detects the load in the
first minute: the indicator flashes, the
bars under the icon move back and
forth
and the drum rotates
shortly.
2. When the drum stops rotating, the
display shows the new program
duration adjusted according to the
detected load. The number of bars,
from 1 to 4, represents the estimated
load amount. 4 bars represent the
maximum load amount for the
selected program.
In case of drum overload,
the maximum declared load
indicator comes on again
with the
blinking. In this case, during
these 30 seconds, it is
possible to open the door
and remove the exceeding
garments. Once removed,
touch the Start/Pause button
to start the program again. If
the laundry amount will not
be reduced, the program
starts anyway. In this case, it
will be not possible to
guarantee the best results.
10.11 Program change
To change a program:
1. Push the On/Off button to turn the
appliance off.
2. Push the On/Off button again to turn
on the appliance.
3. Set a new program.
10.12 Program end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the End
ENGLISH
23
indicator
Advertisement
Table of Contents
