Alignment - Sony CA-325A Service Manual

SECTIONS
ALIGNMENT
3-1. PREPARATION
3-1-1. Equipment Required
¢ Oscilloscope (probe x 2)
¢ Power cord
¢ Video camera DXC-325/P
Note: Be sure to use a completely adjusted camera
for correct adjustment.
¢ Digital volt-meter
3-1-2. Connections
Set the camera as follows.
DXC-325,/P
CA-325A/AP
Connecting the CA-325A/AP to the camera
1. Remove the three screws (+ B3 x5) which fix
the front panel to CA-825A/AP.
2. Remove the front panel.
3. Remove the two screws (+ PWH8 x 6) which fix
the floating board.
PANEL, FRONT
- CA-325A/AP (UC, EK)
31
4. Remove the four screws (+ B35) which fix the
side plate ASSY.
5. Pull out the side plate ASSY from the cabinet.
Note: This time, do not pull it forcibly, because
the harness may be damaged.
+B3x5
PLATE,
SIDE
6. Connect 50 pin connector with DXC-325/P.
7. Draw CN7 connector from DR-95 (A) / (AP).
3. ALIGNMENT |} HIHITIHII