Table of Contents
Advertisement
Hex nut with conical washer
Ecrou Hexagonal muni d'une rondelle conique
Tuerca hexagonal con roldana conica
ASSEMBLY INSTRUCTIONS
BEFORE ASSEMBLING YOUR EDGER, CHECK THAT YOU HAVE RECEIVED THE
FOLLOWING IN THE SHIPPING CARTON. SEE FIGURE 1.
A. LE750 Landscape/Edger
B. Edger blade with nut, conical washer and spacer system (assembled to unit)
C. Handle tube bolts and knobs (assembled to handle tubes)
D. Auxiliary handle, with bolt and knob.
ASSEMBLING THE HANDLE
Assemble Handle Tubes (Figure 2 and 3)
1. Remove knobs and curved head bolts from handle tube mounting holes.
2. Remove tape which secures internal jacketed cable to tubes.
3. Slide middle tube into upper tube and fasten handle tubes together with the knob and
curved head bolt. Note that when you first insert the bolt it may be necessary to wiggle it
carefully to get it past the jacketed cable inside the tube. There are two positions
available for adjustment to your preferred height setting. See Figure 11 for upper handle
orientation. Ensure the cable moves smoothly into the handie tubes while assembling.
4. Push jacketed cable down into
mes Ge, teen. ean iene a,
into
_ _
the lower by locating the groove and the bump. Fasten handle tubes together
with
remaining knob and curved head boii Note that when you fai kaat ie ole wer
necessary
to waggle @ carefully tp get f past The jacketed wire inside
the tube.
A\CAUTION: NEVER use a sharp object to move jacketed wires out of the way.
POSITION AUXILIARY HANDLE (FIGURE 4)
1. Undo the knob from the bolt in the auxiliary handle and push/pull the bolt out of the handles
Advertisement
Table of Contents
