Advertisement
Functions
BEFORE FIRST USE
Remove any promotional material attached to
your kettle. It is recommended that before first use,
the kettle is filled to the maximum level with cold
tap water, boiled and water discarded. Your kettle
will only operate when positioned on the power
base with the 'On/Off' switch in the 'On'position.
The kettle will automatically switch off once the
water has boiled.
OPERATION OF YOUR KETTLE
To fill the kettle, remove it from the power base
and open lid by pressing the lid release button.
Fill with the desired amount of water.
NOTES
• Always fill the kettle between the minimum and
maximum marks on the vessel. Too little water
will result in the kettle switching off before the
water has boiled. Filling above the maximum
mark (MAX) may result in boiling water
splashing from the kettle.
• Ensure the lid is locked firmly into place.
• Position the kettle securely onto the power base.
• Insert the power plug into a 230/240V power
outlet and switch on.
• Press the 'On/Off' switch to the 'On' position for
water to boil.
IMPORTANT NOTE
This kettle must only be used with the power base
supplied. Use caution when pouring water from
your kettle, as boiling water will scald. Do not pour
the water too quickly. The kettle will automatically
switch off once the water has boiled. Lift the kettle
from the power base and pour the water. Take care
to hold the kettle level, especially when filled to
the maximum level. To re-boil it may be necessary
to wait for up to 30 seconds to allow the control to
reset. If further heating of the kettle is not required,
switch off at the power outlet, unplug the power
cord and empty the water from the kettle. Replace
the kettle onto the power base and close the lid.
8
SAFETY BOIL DRY PROTECTION
The kettle is fitted with a safety device, which
protects against overheating should the appliance
be operated with insufficient water. If this occurs,
the kettle will stop heating. Switch off at the power
outlet and allow kettle to cool before refilling.
Remove the kettle from the power base and add
water. Return the kettle to the power base. The
safety device will then automatically reset.
For additional safety, your kettle is fitted with
an additional thermal cut out. In the event of
overheating, the kettle will automatically shut
down to prevent further damage. Should this
occur, take your kettle to an authorized Breville
Service Centre.
®
Advertisement
