Sealey MC5908.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
Refer to Wear safety
instruction footwear
manual
1. SAFETY
WARNING! Before use, ensure that the motorcycle to be supported, has a suitable structure and centre of gravity to accommodate the
‰
platform, without damaging the motorcycle. DO NOT use if the stand will foul on the exhaust or other vulnerable parts.
Maintain the stand in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Use a qualified person to lubricate and maintain the stand.
9
Locate the stand in a suitable work area. Keep area clean and tidy and free from unrelated materials and ensure that there is adequate
9
lighting. Also ensure that the floor is level and strong enough (preferably concrete) to take the weight of the stand and the bike.
DO NOT operate the stand on tarmacadam, as the surface may be unstable.
8
Keep the stand clean for best and safest performance.
9
The maximum bike weight is 450kgs. DO NOT exceed this rated capacity.
9
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair.
9
Maintain correct balance and footing, DO NOT over reach. Ensure that the floor is not slippery and wear non-slip shoes.
9
Ensure that the bike is adequately secured to the stand with appropriate straps.
9
Before lifting check that there are no overhead obstructions.
9
Keep children and unauthorised persons away from the work area.
9
DO NOT use the stand for a task it is not designed to perform.
8
DO NOT operate the stand if damaged.
8
DO NOT exceed the rated capacity of the stand.
8
DO NOT operate the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT allow untrained persons to operate the stand.
8
DO NOT make any modifications to the stand.
8
Before lowering the stand ensure that there are no obstructions underneath the motorcycle and that all persons are standing clear.
9
Before storing, ensure that all parts are clean and free of grease and oil and the stand is fully lowered. Store stand in a safe area.
9
WARNING! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that
‰
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
WARNING! Maximum load capability is only available above 115mm table height.
‰
2. INTRODUCTION
Scissor support stand suitable for use either on a motorcycle lift or on the floor. Fitted with ball-bearing rollers for smooth lifting and
lowering. Raise by hand with sliding T-bar provided or driven using a 21mm socket (not provided). Supplied with non-slip platform cover
for added load security.
3. SPECIFICATIONS
Model no: MC5908.V2
Capacity: 450kg
Minimum height 85mm
Maximum height 365mm
© Jack Sealey Limited
450KG SCISSOR STAND FOR MOTORCYCLES
MODEL NO:
No
reaching in!
Original Language Version
MC5908.V2
MC5908.V2 Issue:2 (1) 16/11/23