Summary of Contents for Zenith D60DVSA
- Page 1 D60DVSA D60DVSA D60DVSAS D60DVSAS 60V PDP Speakers & Speaker Stand Installation and Setup Guide P/NO : 3828VA0279B...
-
Page 2: Speaker Installation
Speaker Installation - Speakers can be mounted: On the Monitor, (See below) On a flat desk-type surface. (See page 3) Or, on the floor. (See page 3) Speakers mounted on the monitor Speakers mounted on the monitor ... - Page 3 Speakers shown mounted on the speaker stands Speakers shown mounted on the speaker stands Speakers shown mounted on the floor stands Speakers shown mounted on the floor stands 206-3732...
- Page 4 60V PDP Speakers Mounting speakers on Monitor Mounting speakers on Monitor Caution: Always lift the monitor itself (not the speakers) when handling or moving the monitor after speakers have been installed. When screwing bolts into the Monitor and speakers, tighten the bolts enough so that they are secure. If the bolts are tightened too much, the product could be damaged.
- Page 5 Caution: Unplug monitor power cord from power outlet before making any connections. Place the speakers in the position you want. Install the speaker wires on the monitor and speaker. Be sure to connect the positive “+” wire to the “+” input and the negative “-“ wire to the “–“ input. Connect left monitor input to left speaker and right monitor input to right speaker.
- Page 6 Accessories Accessories 4-Iron Plates (Mount speakers 8- Small Bolts (Attach iron to monitor.) plates to speakers.) 4-Large Bolts (Attach iron 2-Speaker Wire Holders (for plates to monitor.) arranging the speaker wires.) 2-Speaker Wires Installation and Setup Guide 206-3732...
-
Page 7: Specifications
Specifications Specifications Name of Product Impedance (ohms) Rated Input (watts) Maximum Input (watts) Width (inches / mm) Height (inches / mm) Depth (inches / mm) Weight (pounds / kg) 206-3732 60V PDP Speakers 5.3 / 135 34.8 / 883 3.9 / 99 5.5 / 2.5... - Page 8 How to mount speaker on Speaker stand Speaker Assemble each speaker stand and speaker by screwing the two bolts in the clockwise direction shown in 1 above. See the magnified view to identify the two screw bolt holes. To detach the speaker form the stand, unscrew the two bolts in the opposite direction.
- Page 9 Weight (pounds / kg) 206-3732 Installation and Setup Guide 60V PDP Speaker stand 8.7 / 220 8.6 (38.5) / 218 (978.5) *The value in ( ) is the height of the assembled speaker and stand. 8.7 / 220 4 / 1.8...
- Page 10 Memo 206-3732...
- Page 11 Memo 206-3732...
- Page 12 206-3732...