Table of Contents
Advertisement
2
Neighboring network
3
Point of measurement
4
Low voltage
5
Equipment (victim)
2.
An EMC plan for preventing disturbances is drawn up for the installation. A template is
available from the local ABB representative.
3.
The generator and control cables are selected as specified in the hardware manual.
4.
The converter is installed according to the instructions given in the hardware manual.
WARNING!
A drive of category C4 is not intended to be used on a low-voltage public network
which supplies domestic premises. Radio frequency interference is expected if
the converter is used on such a network.
ETL marking
ETL marking is pending.
The converter provides overload protection in accordance with the National Electrical Code
(US) and Canadian Electrical Code (Canada). See the firmware manual for setting. Default
setting is off; the setting must be activated at start-up.
The converters are to be used in a heated indoor controlled environment. See the ambient
conditions for specific limits.
WEEE mark
WEEE mark
At the end of life the product should enter the recycling system at an appropriate collection point
and not placed in the normal waste stream.
GL2010
Available on request.
Disclaimers
Generic disclaimer
￭
The manufacturer shall have no obligation with respect to any product which (i) has been
improperly repaired or altered; (ii) has been subjected to misuse, negligence or accident;
(iii) has been used in a manner contrary to the manufacturer's instructions; or (iv) has failed
as a result of ordinary wear and tear.
Cybersecurity disclaimer
￭
This product can be connected to and to communicate information and data via a network
interface. The HTTP protocol, which is used between the commissioning tool (Drive
Composer) and the product, is an unsecured protocol. For independent and continuous
7
Supply transformer
8
Static screen
9
Converter
-
-
Technical data 97
Advertisement
Table of Contents
