Operating The Quick Stick; Clearing A Clogged Discharge Chute - Toro Power Max 826 OAE Operator's Manual

Operating the Quick Stick®
Hold the blue trigger cap down to use the Quick Stick
to move the discharge chute and the chute deflector.
Release the trigger cap to lock the discharge chute
and chute deflector into position
Figure 21
Moving the Discharge Chute
Hold the blue trigger cap down and move the Quick
Stick to the left to move the discharge chute to the
left; move the Quick Stick to the right to move the
discharge chute to the right
Figure 22
•
If the chute does not move, refer to
Discharge-Chute Latch (page
•
If the chute does not turn as far to the left as it
does to the right, ensure that the cable is routed
to the inside of the handles. Refer to
the Chute-Control Rod (page
•
If the chute does not lock into place when you
release the trigger cap, refer to
Discharge-Chute Latch (page
(Figure 21).
g001014
(Figure 22).
g018894
Adjusting the
24).
4 Installing
7).
Adjusting the
24).
Moving the Chute Deflector
Hold the blue trigger cap down and move the Quick
Stick forward to lower the chute deflector; move it
rearward to raise the chute deflector
Clearing a Clogged
Discharge Chute
WARNING
If the auger/impeller is running but there is no
snow coming out of the discharge chute, the
discharge chute may be clogged.
Never use your hands to clear a clogged
discharge chute. This could result in personal
injury.
•
To unclog the discharge chute, stay in the
operating position and release the left (traction)
lever. While running the auger/impeller, push down
on the handles to raise the front of the machine a
few centimeters (inches) off the pavement. Then
lift the handles quickly to bump the front of the
machine on the pavement. Repeat if necessary
until a stream of snow comes out the discharge
chute.
•
If you cannot unclog the discharge chute by
bumping the front of the machine, shut off the
engine, wait for all moving parts to stop, and
use the snow-cleanout tool
Important:
Unclogging the discharge chute
by bumping the front of the machine on the
pavement may cause the skids to move. Adjust
the skids and tighten the skid bolts securely;
refer to Checking and Adjusting the Skids and
Scraper (page 20).
17
(Figure 23).
Figure 23
(Figure 13).
g001016