4. Open the latch and disconnect the keyboard cable from the keyboard-controller board.
5. Pull on the securing tab to release the keyboard-controls board from the palm-rest assembly.
6. Using the plastic tab, pry and remove the keyboard-controller board from the palm-rest assembly.
Installing the keyboard-controller board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the keyboard-controller board and provides a visual representation of the installation
procedure.
Steps
1. Using the alignment posts, adhere the keyboard-controller board into place on the palm-rest assembly.
2. Connect the keyboard-controller board-cable to the keyboard-controller board and close the connector latch.
3. Connect the keyboard cable to the keyboard-controller board and close the connector latch.
4. Connect the keyboard-backlight cable to the keyboard-controller board .
5. Replace the two screws (M2x1.9) that secure the keyboard-backlight cable to the keyboard-controller board.
Next steps
1. Install the battery.
2. Install the
2230 solid-state
3. Install the
2280 solid-state
4. Install the
base
cover.
5. Follow the procedure in
drive. (if applicable)
drive. (if applicable)
After working inside your
computer.
31