Table of Contents
Advertisement
TROUBLESHOOTING
If the unit fails to operate normally, check the following points to determine whether the problem can be corrected by the simple measures suggested. If it
cannot, or if the problem is not listed in the SYMPTOM
column, disconnect the unit's power cord and contact your dealer or service center for assistance.
SYMPTOM
PROBABLE
CAUSE
REMEDY
The player does not switch ON when the
POWER
switch is pressed.
The disc tray does not close completely.
connected.
The power cord is not connected or not completely
A foreign object is obstructing the tray.
Securely connect the power cord.
Carefully check the disc tray and remove the
foreign object.
|
A disc number
does not illuminate in the
display.
The disc is damaged.
Play is delayed, or begins at the wrong
place.
No sound.
Sound
"skips".
Sound
"hums".
Noise from a nearby tuner.
Noise from within the disc tray.
The disc may be warped.
SPECIFICATIONS _
AUDIO SECTION
Frequency
response
............. 20 Hz — 20 kHz, +0.5 dB
De-emphasis equalization
............................. +0.5 dB
Harmonic
distortion
+ noise
....Less than 0.0035%
(1 kHz)
S/N TANG: i ooo
eue
аи
Ue bred 105 dB
Dynamic range
............................... More than 95 dB
Wow & flutter ионов
Unmeasurable
Channel separation ................ More than 85 dB (1 kHz)
Output voltage г.с
осна нао
атый 2+0.5V
Headphones output (—20 dB) ...... 200 + 20 mV/150 ohms
18
The disc has been loaded upside down.
There is moisture on the iaser pickup.
Wait 20 to 30 minutes
after switching the unit ON
before trying to play a disc.
Play does not begin.
The disc has been loaded upside down
Reload the disc with the labe! side up.
The disc is dirty.
The disc may be scratched or damaged.
Improper output cable connections.
Improper amplifier operation.
Set the amplifier controls to the correct input
selection.
The player is being subjected to vibrations or
Relocate the player.
impacts.
The disc is dirty.
Clean the disc.
' Improper cable connections.
The tuner is too close to the player.
Load the disc correctly.
Check the disc carefully; replace it if necessary.
Clean the disc.
Check the disc carefully; replace it if necessary.
Connect the cables properly. If the problem
persists, the cables may be defective.
Securely connect the audio cables. If the problem
persists, the cables may be defective.
Move the tuner and player farther apart.
Replace the. disc.
GENERAL
Power requirements
U.S.A. and Canada models
.................. 120V, 60 Hz
Australia and U.K. models
.................... 240V, 50Hz
Europe model
................................... 220V, 50 Hz
General
model
......... 110 — 120/220 - 240V, 50/60 Hz
Power consumption
....................................... 20W
Dimensions (W x H x D) ........... 435 x 107.5 x 377 mm
NONE
(17-1/8" x 4-1/4" x 14-13/16")
Weight Rr
6.2 kg (13 Ibs. 10 oz)
Accessories
.................................... Connection cord
Remote
control cable
Remote
control transmitter
Batteries (size "AAA", R03)
Please note that all specifications are subject to change
without notice.
Advertisement
Table of Contents
