Getting Started Ee; Setting Up The Power Supply; Hook-Up Terminals For Attachments - Yamaha PortaSound PSS-795 Owner's Manual

Owner's Manual
a. Setting up the power supply
The PSS-795 can be operated using either batteries or a
standard outlet.
a) When you are using batteries
Flip the PSS-795 over and open the battery case. Insert six
batteries (dry cells: 1.5V SUM-2 or R-14) all facing the
same direction as shown. Replace cover.
D
In case batteries' voltage are low, you hear the sounds distorted. If you
go on using the PortaSeund, «bt chn» indication will be shown. In this
case, it's the time to replace all of 6 batteries with new ones.
Do not use the batteries of different types other than listed above.
b) When using an electrical outlet
An authorized optional AC adaptor (YAMAHA PA-3, PA-4 or
PA-40) must be used. The adaptor is plugged into the DC
9-12V IN terminal located on the back of the instrument.
a
MIDI
* There are different types of AC adaptors, be careful to use only the
models mentioned above.
* If you leave the instrument without any power supply (batteries or
adaptor) for a long period, your record in the Song Memory (explained
later) will be lost, and the PSS-795 will be in the original status when
shipped. But you don't mind the amount of time for changing batteries —
1 minute at most. This short period will not cause this to occur.
b. Hook-up terminals for
attatchments
б [51
MIDI
* Before inserting plugs in, MAKE SURE the volume controls on the
amplifiers are turned all the way down to prevent damage to the
speakers.
Note: in both cases of attatchments (headphones and
amplifiers), the Master Volume control located on the PSS-
795 can be used in controlling levels of volume.