Editing Drum Voices - With The Drum Setup Controls - Yamaha MU100 Owner's Manual

Editing Drum Voices — with the Drum Setup Controls
The Drum Setup Controls provide a comprehensive set of tools for control-
ling and changing the drum Voices. These parameters can be set individually
for each sound in a Drum Part. Up to four of your original editing setups can
be permanently stored.
Unless you've set them otherwise, Parts 10 and 26 are automatically set
to play a Drum Part and the MIDI channel for both is set to 10. (General
MIDI song data is standardized for playing drum/percussion sounds over
channel 10.)
For the sake of these instructions, we'll simply select Part 10 and edit the
existing Drum Part. However, you can set up additional Drum Parts on any
of the Part numbers; refer to the box section below.
Remember that once a Part is assigned a Drum Part and different drum
Voices can be selected. (Refer to the "Sound List & MIDI Data" booklet.)
Assigning a Drum Part
This operation allows you to assign a Drum Part to any of the Part numbers —
letting you use two or more different drum Voices within the same song.
1. Select the desired Part.
2. Call up the Edit menu.
3. Select and call up the OTHERS menu.
4. Select the Part Mode parameter.
5. Set the parameter to "drumS1."
Details
• The "normal" setting is for normal Voices; the "drum" setting selects the
6. Press the [EXIT] button.
Use the [PART -/+] buttons.
Press the [EDIT] button.
Use the [SELECT </>] buttons, then press [ENTER].
Use the [SELECT </>] buttons.
Use the [VALUE -/+] buttons or data dial. As long as you select one of
the "drum sets" (drumS1 – drumS4), any edits you make will automatically
be saved to the selected set.
Drum Part, but cannot be edited. (For more information on the Part Mode,
see page 108.)
Press it once to return to the Edit menus, twice to return to the Play dis-
play.
Guided Tour
Editing in the Multi Mode
55