Mounting To A Microphone Stand; Optional Mic Stand - Yamaha MG8/2FX Owner's Manual

Mounting to a Microphone Stand

When using the mixer on a microphone stand, be
•
sure to set the stand on a level and stable surface.
Do not set up the stand in locations subject to
vibrations or wind.
Note that mixer may be damaged if the stand
•
should fall over. Attach the connection cables
carefully so that the cables will not catch on the
equipment and cause it to fall. For example:
arrange the cables so that they run parallel with
the microphone pole down to the base of the
stand.
Leave ample free space around the stand.
•
1
Turn the mixer upside-down, and hold the micro-
phone-stand adaptor (BMS-10A; sold separately)
against the bottom of the mixer so that the screw holes
are aligned ( 1 ).
Screw the adaptor firmly into place with the two
screws ( 2 ).
2
Turn the mixer right-side up, and mount it onto your
microphone stand.
2
1
3
Loosen the angle adjustment wingnut ( 1 ), adjust the
mixer's angle as desired ( 2 ), and then tighten the
wingnut securely ( 3 ).
For more information, refer to the BMS-10A Owner's Man-
ual.
Setting Up
2
3
1
MG8/2FX
21