Hints And Tips - AEG CL838MM User Manual

Table of Contents

Advertisement

Available languages

Available languages

Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
10.10 Opening the door while the
appliance operates
Opening the door while a programme is
running pauses the wash cycle. The display
shows the remaining duration of the
programme. After closing the door, the wash
cycle resumes from the point of interruption.
Opening the door while the remote start is
activated deactivates this function. Activate
the remote start again before you close the
door; otherwise, the wash cycle starts
immediately after you close the door.
Opening the door does not deactivate the
remote start if the delay start is set.
If you open the door during the delay start
countdown, the countdown is paused. The
display shows the current countdown status.
After closing the door, the countdown
resumes.
Opening the door while the appliance
operates may affect the energy
consumption and the programme
duration.

11. HINTS AND TIPS

11.1 General
Follow the hints below to ensure optimal
cleaning and drying results in daily use and to
protect the environment.
• Washing dishes in the dishwasher as
instructed in the user manual usually
consumes less water and energy than
washing dishes by hand.
• Load the dishwasher to its full capacity to
save water and energy. For best cleaning
results, arrange items in the baskets as
instructed in the user manual and do not
overload the baskets.
• Do not pre-rinse dishes by hand. It
increases the water and energy
52
ENGLISH
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by the
AirDry function.
10.11 The Auto Off function
This function saves energy by switching the
appliance off when it is not operating.
The function comes into operation
automatically:
• When the programme is completed.
• After 5 minutes if a programme was not
started.
10.12 End of the programme
When the programme is complete, the
display shows 0:00.
The Auto Off function switches the appliance
off automatically.
All buttons are inactive except for the on/off
button.
If the display shows upd, refer to
"Troubleshooting".
consumption. When needed, select a
programme with a prewash phase.
• Remove larger residues of food from the
dishes and empty cups and glasses
before putting them inside the appliance.
• Soak or slightly scour cookware with firmly
cooked-on or baked-on food before
washing it in the appliance.
• Make sure that items in the baskets do not
touch or cover each other. Only then can
the water completely reach and wash the
dishes.
• You can use dishwasher detergent, rinse
aid and salt separately or you can use the
multi-tablets (e.g. ''All in 1''). Follow the
instructions on the packaging.

Advertisement

Chapters

Table of Contents
loading

Table of Contents