Yamaha 02R96 Owner's Manual page 122

122
Chapter 11—Common Channel Functions
In Mixdown Solo mode, soloed Input Channel signals are fed to the Stereo bus and output
via the Stereo Out and Control Room Outputs. Unsoloed Input Channels are muted and
their [ON] button indicators flash (unless they are Solo Safe enabled). Only Input Channels
that are routed to the Stereo Out can be soloed in this mode. Input Channels that are off are
temporarily turned on when they are soloed.
SEL MODE: This determines the Solo Select mode: Mix Solo or Last Solo. In Mix Solo
mode, any number of channels can be soloed simultaneously. In Last Solo mode, only one
channel can be soloed at a time.
LISTEN: This determines the source of the Input Channel Solo signal: Pre Fader or After
Pan. It does not affect Mixdown Solo mode. Output Channels are fixed at After Pan. If you
select Pre Fader, turning on the PAN button below it enables you to solo the channel with
the Pan setting still applied.
SOLO TRIM: This is used to trim the level of the Solo signal. This parameter does not
affect Mixdown Solo mode.
SOLO SAFE CHANNEL: For Mixdown Solo mode, Input Channels can be configured
individually so that they are not muted when other Input Channels are soloed. Use the
[SEL] buttons, cursor buttons, or Parameter wheel to select the SOLO SAFE CHANNEL
buttons. Use the [ENTER] or INC/DEC buttons to set Solo Safe for each Input Channel.
These settings do not affect Recording Solo mode. You can clear all Solo Safe settings by
selecting the ALL CLEAR button and pressing [ENTER].
AUX/SOLO LINK: When this check box is checked, you can solo or unsolo the Aux Sends
using the AUX SELECT [AUX 1]–[AUX 8] buttons without changing the Master layer. This
is convenient when you want to solo or unsolo Aux Outs while controlling the Aux Sends
from the Input Channels. Press the AUX SELECT key for the AUX send that you want to
solo, making it light. Then press that key once again to solo only the selected AUX send.
When Aux Sends are soloed, the corresponding AUX SELECT button indicators flash.
FADER/SOLO RELEASE: When you check this check box, raising the channel faders of
soloed Channels from – ∞ will unsolo the Channels. If the channel fader position is higher
than – ∞ , you cannot solo the corresponding channel.
This function is disabled in Mixdown Solo mode and for the Output Channels.
Note: When the AUX/SOLO LINK or FADER/SOLO RELEASE check box is checked, the solo
setting is cancelled.
02R96 Version 2—Owner's Manual