Kenwood TM-201B Instruction Manual page 10

@ COMMUNICATIONS SPEAKER INSTALLATION
Note: For safetys sake, do not install the speaker on the ceiling.
Example 1-2 Example 2-2
cit toss)
Speaker =
\ , Mounting Mounting
surface ~ \ surface
Cushion (A) \
| Tapping screw [oo 9 0 0| Round head
(64x 8) screw
{64x 10)
Bracket
Mounting
surface
| Gushion 1a) opie
Example 2-4
a rm a
} a
@ 3 =
Cushion (A)
°
oe
Tapping screw
dul
(94x 8)
Bracket
fushion:
Example 2-8
ey wb
'Speaker gal
Nee
Cushion (A) « < <
eS
Bracket
Ye
Ne
S
* Installation procedure
1) Secure the bosses on each side with 4 flat head screws. (Fig. a)
2) Affix the cushion (c) on each side of the mounting bracket. (Fig. b)
3) Secure the mounting bracket to the chassis as shown in Fig. c.
When installing the bracket, be sure the front part of the bracket faces you.
4) Insert the transceiver as shown in Fig. d so the bosses on the transceiver
slide into the grooves of the mounting bracket.
5) To stack with the TM-401B (70 cm), first secure the supplied stack plate
to the TM-201B with bosses then stack the TM-401B, second insert the
stacked transceivers as shown in Fig. d so the bosses on the upper
transceiver slide into the grooves of the mounting bracket.
Fig. © Boss securing
Fiat head - Boss Flat
Be sure to use flat washers. However, when
stack instelistion with the TM-401B is at-
'tempted, do not use these washers since the
stack plates are used.