Timing the First and Second
Place Finishers
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
Hours
Minutes, seconds,
1/100 seconds
2.
Use the operations below to measure
elapsed time.
D
Start
A
1st Finisher*
D
2nd Finisher*
* This displays the time of the first
finisher.
3.
Press (A) to display the time of the second
finisher.
4.
Press (A) to reset the measurement time
to all zeros.
Watch Operation Guide 3545
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper is muted when battery power is
●
low.
Timer
Setting the Time
The countdown start time can be set in 1-
minute units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
This causes the hours digits to flash.
Hours
3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to change the timer
minutes setting.
6.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Setting a start time of [0:00] performs
●
a countdown of 24 hours.
13