Mounting The Rear And Rear Center Speakers - Yamaha NS-P326 Owner's Manual

Mounting the rear and rear center speakers

1
2
3
60 mm
Diam. 3.5 to 4 mm
Min.
20 mm
6 mm
Tapping screw
(Available at the
hardware store)
Mount the rear and rear center speakers on a shelf, rack or
directly on the floor, or hang them on the wall.
To mount the rear and rear center
speakers on a wall by using the holes
on the speakers' back panels
1
Put the provided pads at the four corners on the rear of
the rear and rear center speakers to prevent the rear
and rear center speakers from moving by vibrations.
2
Fasten screws into a firm wall or wall support as shown
in the figure.
3
Hang the holes on the protruding screws.
* Make sure that the screws are securely caught by the
narrow parts of the holes.
* You can use the lower holes on the rear of the rear
speakers.
WARNING
● Each speaker weighs 1.1 kg (2 lbs. 6 oz.). Do not
mount them on thin plywood or a wall with soft
surface material. If mounted, the screws may come
out of the flimsy surface and the speakers may fall.
This damages the speakers or causes personal
injury.
● Do not install the speakers to a wall with nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause them to fall.
● To avoid accidents resulting from tripping over loose
speaker cables, fix them to the wall.
● Select a proper position on the wall to mount the
speaker so that no one will injure his/her head or
face.
Holes
5
E-