Table of Contents
Advertisement
WARNING
I
To avoid injury to personnel and damage, to the equip-
ment, at least two men are required to handle the
mass storage unit expansion drawer.
4.
Lift drawer out of inner shipping container and place
drawer upright on a work bench (on the rubber feet).
5.
Remove polyethylene dust cover from mass storage unit
expansion drawer.
2.1.2
Removing Shipping Hardware from Expansion
Drawer
To remove the shipping hardware from the mass storage unit
expansion drawer proceed as follows:
2-2
1.
Raise drawer mount case (see Figure 2-1) as follows:
a.
Press in on release catches located on bottom outside
corners of mount case at rear of drawer.
b.
While holding in release catches, lift up on top
cover of drawer.
To prevent damage to the front of the case assembly,
the unit must be extended over the edge of the work
surface.
c.
When top cover of drawer has been raised a short dis-
tance, swing hinged panel at rear of drawer away from
the mass storage unit in order to clear rear of
actuator assembly.
d.
Pivot top cover of drawer up until it rests against
case support.
2.
Within expansion drawer, locate rail bracket assembly
(see Figure 2-2) and remove taped down carriage locking
pin and ring assembly (red tag attached) from SHIPPING
LOCK hole and store assembly in PIN STORAGE hole.
HONEYWELL CONFIDENTIAL & PROPRIETARY
--
_
..
_--
/
"
Advertisement
Table of Contents
