Exterior Surfaces - GE 600 Series Owner's Manual

Exterior Surfaces

Be sure all controls are off and all surfaces are cool before cleaning any part of the range.
anti-tip device is reengaged properly when the range is replaced. Failure to take this precaution
could result in tipping of the range and can result in death or serious burns to children or adults.
NOTE: DO NOT allow stainless steel cleaner to come in contact with any plastic parts such as
the control knobs or control panel. If unintentional contact of cleaners with plastic parts does
occur, clean plastic part with a sponge and mild detergent mixed with warm water.
Control Knobs
The control knobs may be removed for easier cleaning.
Make sure the knobs are in the OFF positions and pull
them straight off the stems for cleaning. The knobs can
be cleaned in a dishwasher or they may also be washed
Control Panel
It's a good idea to wipe the control panel after each use.
Clean with mild soap and water or vinegar and water,
rinse with clean water and polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleansers,
plastic scouring pads or oven cleaners on the control
panel - they will damage the finish.
Oven Exterior Surfaces
Clean with a mild soap and water or a 50/50 solution of
vinegar and water. Rinse with clean water and dry with
a soft cloth. When cleaning surfaces, make sure that
they are at room temperature. Spillage of marinades,
fruit juices, tomato sauces and basting liquids containing
acids may cause discoloration and should be wiped up
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.
Fingerprint Resistant Stainless Steel and Other Finishes (on some models)
DO NOT use stainless steel cleaners on fingerprint
resistant stainless steel surfaces.
IMPORTANT: The use of incorrect products may
damage the outer finish of Fingerprint Resistant
Stainless and other finishes (i.e. white, black stainless,
slate, etc.). Please follow these instructions and use
24
WARNING
If your range is removed for cleaning, servicing or any reason, be sure the
with soap and water. Make sure the inside of the knobs
are dry before replacing. Replace the knobs in the OFF
position to ensure proper placement.
If desired, the touch pads may be deactivated before
cleaning. To lock or unlock the controls, press and hold
the Lock Control pad for three seconds.
as soon as hot surfaces cool, then clean and rinse. For
other spills such as fat spatterings, wash with soap and
water after the surface has cooled. Rinse well.
Do not use commercial oven cleaners, cleaning powders,
steel wool or harsh abrasives on any exterior surface.
Soft Cleanser™ will remove surface rust, tarnish and
and rub in the direction of the brush lines with a damp,
soft sponge. Wipe the appliance surface dry with a soft,
clean cloth or microfiber towel to avoid streaking or water
spotting and making sure to remove all cleaning residue.
only the appropriate items below to clean your appliance
surfaces. Clean interior/exterior surfaces with warm
water, mild soap or detergent, and a soft or microfiber
cloth to avoid damage. Wipe the appliance surface
dry with a soft, clean cloth or microfiber towel to avoid
streaking or water spotting and making sure to remove
all cleaning residue.
49-2001193 Rev. 0