Advertisement
The lightning fash with arrowhead, within an equilaterat
triangle, is intended to alert the user to the presence of
| uninsuiared "dangerous voltage" within the product's
enclosure that may be of sufficient magnitude to constinute
a tisk of electric shock to persons.
CAUTION
RISK OF ELECTRIC SHOCK
DO. NOT OPEN
CAUTION:
TO PREVENT YHE RISK OF ELECTRIC SHOCK, DO
NOT
REMOVE
COVER
{OR
BACK}
NO
USER.
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The exclamation point within an equilateral iangle is
imended to slert the user to the presence of important
operating and maintenance (servicing) instructions in
the fterature accompenying the appliance
| IMPORTANT
FOR USE IN THE UNITED
KINGDOM
The wires in this mains lead sre coloured in
accordance with the following code:
blue
neutral
brown five
if the plug provided is unsuitable tor your socker
outlets, the plug must be cut off and a suitable plug
'The cut-off plug should be disposed of and must not be
inserted into any 13 amp socket as this can result in
electric shock, The plug ot adaptor or the distribution
pane! should be provided with 13 amp fuse. As the
colours of the wires in the mains lead of this appliance
may
not
correspond
with
coloured
markings
identifying the terminals in your plug, proceed as
foliows:
The wite which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
tO the terminal which is marked with the letter L or
Bo not connect either wire to the earth terminal of a
three pin plug.
NOTE
After replacing or changing 4 fuse, the fuse cover in the
plug must be teplaced with a fuse cover which
corresponds to the colour of the insert in the base of
the plug or the word that is embossed on the base of
the plug, and the appliance must not be used without a
fuse cover. #f lost, replacement tuse covers can be
obtained irom your deafer.
This appliance is rated at 13 amps.
Only 13 amp fuses approved to B.S
1362 A.S.TA.
should be used.
fitted
coloured red.
Lccintinstatsa
Information to User
FEATURES ........
CHECKING THE ACCESSORIES
INSTALLATION
a
ANTENNA CONNECTIONS
CONNECTIONS ........ ees
CONTENTS -
FRONT PANEL FACILITIES
OPERATIONS
partes
TROUBLESHOOTING
. .
SPECIFICATIONS
FM/AM CHANNEL STEP SWITCH
Only multi-voltage models are provided with this switch.
U.K. and Austratian models are not provided with this switch.
The FM/AM CHANNEL STEP switch is located on the rear panei
of the digital synthesizer tuner. Before the tuner leaves the
factory, this switch is set to the channel allotment plan of the area
in which the tuner is sold. When the TUNING button is given a
single push, the frequency display will change as follows:
CHANELL STEP
30/9
so0/1e
He
ker
[100 kHz/10 kHz] position:
Set to this position for areas with FM reception step of 100 kHz
and AM 10 kHz.
[50 kHz/S kHz] position:
Set to this position for areas with FM reception step of 50 kHz and
AM 8 kHz.
NOTE:
When unsure about the channel allocation for your area, consult
your dealer for correct information.
The channel step will not change if the CHANNEL STEP switch is
operated with the power ON.
After operating the CHANNEL
STEP
switch, if you turn the
POWER
switch OFF and then ON again, the channel step wilt
switch over.
if you operate the CHANNEL STEP switch, the station that were
memorized before the switch was operated will be erased.
2
<ARB1428>
Advertisement
