Recording A Cd: Selecting Tape Length (Tape Select Edit) - Sony MHC-550 Operating Instructions Manual

|4
> continued
2 Press and insert a blank tape into
deck B.
Make sure the tabs on the cassette have
not been removed.
3 Select dual or single-sided recording.
To record Switch DIRECTION
to
One side =
Both sides* Cc
* Recording always stops at the end of the
reverse side. Be sure to start from the
front side.
4 when you want to reduce the hiss noise
in low-level high-frequency signals, set
DOLBY NR to ON.
5 Press @ REC.
Deck B stands by for recording.
viv
eaveoe( 4
ay
vty
nec @
PY
The C (for front side) or <J (for
reverse side) lamp lights steadily to
show you which side will start
recording. The other lamp flashes for a
few seconds, then disappears.
Side in recording
pause mode
For a full explanation of the > and <J
lamps, see "What the [> and <J lamps
indicate" in "Recording a CD
Automatically".
6 if the lamp for the side you want to start
recording does not light, press >> or <J
to light the side to start recording. If it
lights, skip to step 7.
7 Press 00 PAUSE on the tape player to
release recording pause.
Recording starts.
8 Press Pt on the CD player.
The CD starts playing.
To Press
Stop recording @ on deck B
Pause recording 00 PAUSE on deck B
Stop CD play B on the CD player
Pause CD play Pit on the CD
player
Chapter 4: the Tape Player
Adjusting the volume or the audio
emphasis will not affect the recording level
But these controls will change the sound
levels you hear through speakers or
headphones.
= eae ae
Recording a CD:
Selecting Tape Length
(tape select edit)
You can select the most suitable tape length
for recording a CD. The unit automatically
records all of the tracks on the CD in the
same sequence as on that CD on sides A
and B.
The display shows the optimum length of
time needed to record the entire CD. Using
the tape indicated in the display makes it
possible to record the CD without any
tracks being cut off.
POWER—ON
CHECK 2 1
1 Press & OPEN/CLOSE and place a CD.
Then press 2 OPEN/CLOSE again to
close the CD tray.
The total number of tracks, the total
playing time appear in the display.
2 Press EDIT.
"TAPE SELECT" appears in the display,
and the player divides the selections
automatically.
Then the display changes as follows:
3 insert a blank tape of the indicated tape
length (or a longer tape) into deck B.
4 select dual or single-sided recording.
To record Switch DIRECTION
to
One side =
Both sides*® Cc
* Recording will always stup at the end of
the reverse side. Be sure to start from the
front side.
5 when you want to reduce the hiss noise
in low-level high-frequency signals, set
DOLBY NR to ON.
6 Press CD SYNCHRO.
Deck B stands by for recording.
co
A SYNCHRO
Oe Gen
v
Ay
REC: Laan
v
The C= (for front side) ur <I (for
reverse side) lamp lights steadily to
show you which side will start
recording. The other lamp flashes for a
few seconds, then disappears.
7 ifthe lamp on the side you want to start
recording on does not light, press & or
J to light the side you want to start
recording on. [fit lights, skip to step 8.
8S Press 00 PAUSE on the tape player to
release a recording pause.
Recording starts.
The CD starts playing.