Table of Contents
Advertisement
●
Dial Up Networking (DUN)
●
Personal Area Networking (PAN)
●
Serial Port (SPP)
●
Generic Access Profile (GAP)
●
General Attribute Profile (GATT)
7.16.1
Pairing with Low Frequency-Motorola Proximity Pairing
(LF-MPP) Feature
Prerequisites:
Ensure that Bluetooth feature of your radio is on and the Bluetooth tones are enabled.
Bluetooth tones, Bluetooth menu and preprogrammed buttons must be preprogrammed by a qualified radio
technician. Check with your dealer or system administrator for more information.
When and where to use: The range of Bluetooth operation when using a MCW accessory is 10 meters
line-of-sight communication. This is an unobstructed path between the location of the signal transmitter (your
radio) and the location of the receiver (your device or accessory).
Obstacles that can cause an obstruction in the line-of-sight include trees, buildings, mountains, cars, and
others.
For high degree of reliability, Motorola Solutions recommends to NOT separate the radio and the accessory.
At the fringe areas of reception, both voice and tone quality will start to sound "garbled" or "broken". To
correct this problem, simply position the accessory and radio closer to each other (within the 10 meter
defined range) to re-establish clear audio reception.
NOTE: Once a COTS headset is paired to your radio, it is always connected. Therefore the battery life
of the accessory is aligned with the Talk Time power consumption, not the Standby Time consumption.
Procedure:
Turn on the accessory. Then, place it close to the radio aligning the Bluetooth Pairing Location (a blue dot)
on the radio to the Bluetooth Pairing Location (a blue dot) on the accessory.
If the pairing process is successful, you hear an incremental-pitched tone. The radio begins to connect to
the device.
If the pairing process fails, you hear a short, low-pitched tone. The display shows PAIRFAIL. Repeat this
step.
Result:
The radio tries to establish connection with the device once paired.
NOTE: If the connection fails within 6 seconds, you hear a decremental-pitched tone to indicate that the
device is unpaired. The display shows <Device Type> UNPAIRED. Repeat this step to re-initiate the
pairing process.
If the connection is successful, you hear an incremental-pitched tone. The display shows <Device Type>
CONNCTED and the Bluetooth icon turns from
If the radio has the pairing record of the device and the connection fails, you hear a short, low-pitched tone.
The display shows <Device Type> CON FAIL.
to
.
68012005050-FY
Chapter 7: Advanced Features
67
Advertisement
Table of Contents
