Table of Contents
Advertisement
3 Get started
Charge the battery
Note
Before you use your headphones, place them in
the charging box and charge the battery for 2
hours for optimum battery capacity and
lifetime.
Use only the original USB-C charging cable to
avoid any damage.
Finish your call before charging. Connecting the
earpieces to charge will power them off.
If the headset is not used for a long time, the
rechargeable battery will begin to lose its
charge. To avoid this loss, please fully charge
the battery at least once every three months.
Connect the supplied USB charging cable
to:
• The USB-C charging slot on the
headphones and;
• The charger/USB port of a computer.
LED turns white during charging and
turns off when the headphones in
fully charged.
R
Tip
Normally, a full charge takes two hours.
Pair the earpieces with
your Bluetooth device for
the �rst time
1
Make sure that the headphones are
fully charged and powered off.
2
Press and hold the power button for
2 seconds, the headphones will be in
pairing mode and ready to connect.
The LED on headphones �ash
white and blue alternately.
The headphones are now in
pairing mode and are ready to
pair with a Bluetooth device
(e.g. a mobile phone).
3
Turn on the Bluetooth function of
your Bluetooth device.
4
Pair the headphones with your
Bluetooth device, refer to the user
manual of your Bluetooth device.
Note
After powering on, if the headphones can not
�nd any previously connected Bluetooth device,
please put them into pairing mode (press the
power button for 5 seconds).
6
EN
Advertisement
Table of Contents
