Hard Disk Drive (Hdd) - Canon imagePASS-N1 Service Manual

7. Gently lift the power supply out of the chassis.
No.
1 Screw (1 of 4)
To replace the power supply
1. Place the power supply inside the chassis (see above Figure).
Make sure to fit the power connector through the cutout in the chassis. Align the mounting holes in the power supply with
the holes in the chassis.
2. Using the four screws that you removed earlier, secure the power supply to the chassis.
Attach the power supply duct using the two screws that you removed earlier.
3. Connect the HDD power cable to the SATA power connector on the HDD.
IMPORTANT:
Always connect power to the SATA power connector on the HDD. Do not use the PATA (4-pin) power connector, if it is
present on the HDD, and do not connect power to both the SATA and PATA power connectors on the HDD. An incorrect
power connection will result in system errors.
4. Connect the 4-pin (2x2) power cable to the 4-pin connector on the motherboard.
For the location of the motherboard connector,
through 4 of the motherboard connector. The cable is keyed to fit only one way.
5. Connect the 24-pin power cable to the 24-pin connector on the motherboard.
For the location of the motherboard connector,
6. Make sure that all power connectors are properly aligned and securely connected.
7. Secure the power cables to the chassis using the two plastic clips on the base of the chassis.
8. Replace any tie-wraps that you may have removed or cut while removing the power cables earlier.
9. Reassemble the imagePASS and verify its functionality
35).

Hard disk drive (HDD)

The factory-installed HDD is formatted and loaded with system software, network drivers, and printer fonts. The HDD is also used
to store spooled print jobs.
If you must replace the HDD, you must install the system software on the new HDD. If you are replacing the HDD, you need:
• The appropriate system software
Figure 24: Removing the power supply
Item
see"Motherboard jumpers" on page
see"Motherboard jumpers" on page
(see"Restoring imagePASS functionality after service" on page
32
3. REPLACING PARTS
1
20. Connect the power cable to pins 1
20The cable is keyed to fit only one way.