Using The Remote To Control Dvd Functions - Hitachi 46F510 Operating Manual

USING THE REMOTE TO CONTROL
DVD FUNCTIONS
Operating the precoded function for your DVD pJayer.
This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of
your DVD player (refer to page 31 for pre-codes).
1. Turn ON your DVD player.
2. Aim the remote control at the front of your DVD player.
3. Press and release the DVD/VCR button to switch to DVD pre-coded mode.
4. Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your DVD player, as shown on
page 31.
5. Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two
digit preset code is entered. When this occurs, the remote control is programmed for your DVD player, if the DVD player does not
turn off, try a different two digit preset code.
6. The remote will now control your DVD player.
NOTES:
1. if your DVD player cannot be operated after performing
the above procedures, your DVD pbyer's code has not
been preceded into the remote.
2. in the unlikely event that your DVD pbyer cannot be
operated after performing the above procedures, please
consult your DVD player operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
DVD/VCR Button
This button allows the remote to control your DVD player by
setting it to DVD mode.
PRECODED DVD Buttons
These buttons transmit the chosen preceded DVD codes.
@ EXCLUSIVE TV Buttons
These buttons are for operating the TV.
POWER
TV ORL/SAT DVD/VCR
CZD O O_
- -- "_ _w_ _TP_O_E _ " -- -
nEC II I "_'_'T _'_T17£ _
o tc=_-.£1
MY DVD PLAYER CODE IS:
NOTE:
Refer to instruction manuaI of the DVD player for operation of the buttons exclusively for the DVD player.
30